Instructions
for operating BTE.
1.
Turn the machine
on by pushing the white switch on the black box at the bottom of the machine.
2.
Watch the control
panel on the flat surface of the machine (not the top!) until the red “Balancing”
light goes off
3.
Press white “Advance”
button several times until the red light on the control panel reads
“Check ratchet position”.
4.
Turn black dial on
control panel until display at top reads “000”.
5.
Get grip tool
from storage rack behind machine.
6.
Insert Grip tool
into spindle on barrel of machine and tighten.
7.
Press “Up/Down”
button on the box behind the tool to adjust tool to match patient’s
height.
8.
Turn the black
dial on the control panel to set the torque so the resistance is tight enough
for the person to exercise.
9.
Press the “Advance”
button 1 more time until the red light on the control panel reads “Begin
exercise”.
10.
Exercise for 90
seconds
11.
When finished
exercising, wait for the machine to start printing.
12.
Take tool out
while the machine is printing.
13.
Turn off the
machine by pushing the white switch at black box at the bottom of the machine.
14.
Hang tool on
storage rack behind machine.